• 100 pieces aluminum tube flared on one end 5/32" OD 3/32" ID 2.5" long
  • Genuine block Turkish meerschaum pipe kits Mostly dried, may contain some moisture No instructions included, you will have to research methods of meerschaum pipe making, including wether to carve dry or soak wet first We do not sell the beeswax for sealing meerschaum pipes Stones are irregularly shaped and may taper thin towards the top of the bowl and/or have tapered sides or indented areas of the block Thickness (width) of kits vary and are not easily measured 11/16"-1" diameter chamber 5/32" airway Below are some basics about these kits; Push/pull tenon threaded into stem, fits into mortise sleeve that is threaded into mortise Bowl/airway intersection may not be perfect Small cracks and pits are common and can usually be carved down to get past the crack Keep in baggie to let slowly finish drying if you plan to keep it dry, we are not responsible for cracking after you receive a kit due to the fact it is in your control and your environment may change the moisture content in the kit
  • Out of stock
    approximately 100 bone tenons of various sizes
  • A must have for any woodworker Inch fractional to inch decimal to millimeter measures 17.25″ x 22″ backside is a poster of the products we sell
  • Delrin

    $1.50$4.50
    1/4", 5/16", 3/8", and 1/2" comes in 10" lengths 1" comes in 6" lengths
  • Sale!

    Radiator Pipe Base

    $10.00$20.00
    available in 3 colors you will need to ream/drill for stainless steel tubing to have a final fit into the radiator base (hole is drilled in base but is just a little tight for a perfect fit. Reaming is needed) threading is 3/4" x 10tpi if tubing is slightly loose, you can squeeze tube slightly to make a snug fit Loctite 680 is recommended for the final holding in place of stainless steel tubing 1" diameter, 1.5" tall including threaded area
  • Sale!

    Radiator Pipe Mouthpiece

    $2.00$100.00
    molded black acrylic mouthpiece 1.5" long 0.625" button width 0.186" bite zone funneled slot hole that accepts stainless steel tubing is slightly undersized and will need a final reaming/drilling for a proper fit
  • Sale!
    Seamless T304 grade available in 3 lengths; 2.25", 4.4", 5.5" full bent 3/16″ OD 5/32″ ID 1/64″ wall You will need to ream/drill for these to have a final fit into the radiator base or mouthpiece (hole is drilled in base and mouthpiece but is just a little tight for a perfect fit. Reaming is needed)
  • 3/64" diameter the ones without handles in the bottom of the picture are available on the tooling page
  • Stainless Steel Tubing

    $1.85$8.25
    Seamless T304 grade available in 3 lengths; 2.25", 4.4", 10" shorter lengths have trimmed ends, 10" length is rough cut 3/16″ OD 5/32″ ID 1/64″ wall

Title

Go to Top